Wessex Archaeology (WSX) Geophysical Survey WESSEX4: (01/Jul/2003 to 28/Sep/2003)

Geophysical equipment types used included: Echo Sounder and Surface Tow Boomer. Sample equipment types used included: Corer: Vibrocorer. Emu Ltd was contracted to undertake the survey on behalf of Wessex Archaeology. Twenty vibrocores and 245km of seismic survey data were collected over a 3.5km by 1km area, but primarily in a central 1km² around a buried palaeo-channel feature. The geophysical dataset was acquired in three phases. Initially a series of prospection lines were acquired. The survey grid for the second phase had survey lines 3.5km long, orientated NE-SW, at a 50m line spacing. Cross lines were 1km long, orientated NW-SE and at a line spacing of 500m. The aim of this phase of the survey was to collect data in order to confirm the position and orientation of the palaeo-channel feature identified during the propection lines. Once this survey had been completed and the position of the palaeo-channel had been delineated the third phase of surveying was implemented. This involved surveying a 1km block that encompassed the palaeo-channel feature in this area. This 1km block had survey lines 1km long, orientated both NE-SW and NW-SE at a 10m line spacing in both directions. Based on the geophysics results a judgement-led sampling strategy was developed in order to investigate specific research questions. Locations were chosen through the initial interpretation of the sub-bottom profiling data in order to calibrate the geophysical data and confirm the presence of an infilled palaeochannel. On 27th and 28th September 2003, a 6m hydraulic vibrocorer was used to acquire the twenty vibrocores. This work was carried out by a sub-contractor to EMU Ltd. The geophysical survey was conducted aboard the Emu Surveyor between the 1-18 July 2003. The data acquisition was conducted by Emu Ltd under the supervision of WA staff. Single-beam echosounder and sub-bottom profiler data were acquired. Bathymetric data was recorded throughout all stages of the survey using a single beam echo sounder acquired using a Knudsen 320M dual-frequency echosounder. Sub-bottom profiler data were acquired using an Applied Acoustics AA200 surface-tow boomer system and the data were recorded on an Octopus 360 sub-bottom processor. The sub-bottom profiler were originally acquired in *.cod format and were then converted to .sgy format using Coda Utilities 2.6.0 software.

Minimal Distance: 5 urn:ogc:def:uom:EPSG::9001

INSPIRE Implementing rules laying down technical arrangements for the interoperability and harmonisation of unknown theme